NEO-M8N GPS with Compass for Pixhawk with extra connector for APM

This is a new generation NEO-M8N High Precision GPS Module with Built-in Compass for PIXHAWK and APM FC (Ready to connect to PIXHAWK FC) with onboard Compass, low power consumption, and high precision, the ultimate accuracy is 0.6 meters, actually almost 0.9 meters, greater than the previous generation NEO-7N 1.4-1.6 meters accuracy, support GPS/QZSS L1 C/A, GLONASS L10F, BeiDou B1 protocol, and mode or more. Additionally, you can connect the same module to APM Flight Controller just after swapping the extra 5-pin connector provided in Package. So if you want GPS telemetry for your FPV flying or camera ship? This new generation GPS NEO-M8N is the answer. Capable of accuracy between 0.6 and 0.9 meters it is a significant improvement over previous models. Satellite searching and acquisition is very fast, generally taking around ten seconds to locate and acquire up to 6 satellites. It also has a built-in compass with a 10Ghz refresh rate and a low noise figure which ensures this GPS module offers excellent performance. The NEO-M8N provides the best performance and easiest RF integration of all the NEO-M8 configurations. The NEO form factor allows easy migration from previous NEO generations. Sophisticated RF-architecture and interference suppression ensure maximum performance even in GNSS-hostile environments. NEO-M8 combines a high level of robustness and integration capability with flexible connectivity options. The future-proof NEO-M8N includes an internal Flash that allows simple firmware upgrades for supporting additional GNSS systems. NEO-M8N GPS Module for APM APM2.52 APM Flight Controller with Case and GPS Antenna Mount to protect the GPS preventing electromagnetic interference. A new generation GPS NEO-M8N GPS Module, with low power consumption and high precision, the ultimate accuracy is 0.6 meters, actually almost 0.9 meters, greater than the previous generation NEO-7N 1.4-1.6 meters accuracy. Support GPS/QZSS L1 C/A, GLONASS L10F, BeiDou B1 protocol, and mode or more. The NEO-M8N and ceramic antenna make this a very accurate receiver, fast locks & lots of satellites, and the stand is very sturdy to protect the GPS preventing electromagnetic interference. Note: When using 2.8 boards with our GPS module must remove the jumper, if you need to calibrate, make the control and GPS compass direction same and keep the two position fixed(cannot make any move, must fix them on the quadcopter and then calibrate, or it will be failed.) Connector difference of PIXHAWK and APM FC: Note: This Module comes with 6 pin connector connected by default (i.e.Ready to connect to PIXHAWK FC) and extra 5 pin connector for APM FC for Swapping. Features: GPS/QZSS L1 C/A, GLONASS L10F, BeiDou B1 SBAS L1 C/A: WAAS, EGNOS, MSAS Galileo-ready E1B/C (NEO-M8N) Onboard Compass Assistance AssistNow GNSS Online AssistNow GNSS Offline (up to 35 days) AssistNow Autonomous (up to 6 days) OMA SUPL & 3GPP compliant Oscillator TCXO (NEO-M8N/Q), Crystal (NEO-M8M) RTC crystal Built-In Noise figure On-chip LNA (NEO-M8M). Extra LNA for lowest noise figure (NEO-M8N/Q) Anti-jamming Active CW detection and removal. Extra onboard SAW bandpass filter (NEO-M8N/Q) Memory ROM (NEO-M8M/Q) or Flash (NEO-M8N) Supported antennas Active and passive Odometer Traveled distance Data-logger For position, velocity, and time (NEO-M8N) Package Includes: 1 x NEO M8N GPS for Pixhawk and APM flight controller 1 x Extra 5-pin Connector for APM FC Specifications :- Model Ublox NEO-M8N Receiver Type 72-channel Ublox M8 engine. Main Chip Ublox NEO-M8N Input Supply Voltage (VDC) 0.5 ~ 3.6 Sensitivity (dBm) Tracking & Navigation: -161 dBm Position Accuracy (Meter) 2 2.5 Acceleration (g) <4 Navigation Update Rate up to 18 HZ. Operating Temperature Range (C) -45 to 105 Tracking Sensitivity (dBm) -161 dBm Co-Ordinate System WGS-84 Capture Time 0.1s Average Avg Cold Start Time (s) 30 Warm Start Time (s) 1 Boot Time 1S Maximum Altitude (m) 18000 Dimensions (mm) LxWxH 54 x 22 (Dia x W) Weight (gm) 23 Cable Length (cm) 20